Help to remove the powerhead 1985 Evinrude 60Hp

bjnzzle

Cadet
Thread starter
Joined
Aug 11, 2017
Messages
6
Hi guys, newbie here also this is my first post.

I have1985 60hp that can't go at full speed. So ive tested the compression for both pistons and they both were at close to 90psi. I've also check the cylinder and the top cylinder has some scratch line and rough. So I think the piston ring is broken. Now I am trying to remove the power head to remove the piston and check the ring but I am stuck at removing the power head. I unscrewed everything, all the studs but still couldn't lift the power head up. Am I missing something? Thanks so much!
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
If you got the four bolts on each side and the one nut in the rear, you should be good to go. A long, flat blade screwdriver between the head and pan can help.
 

bjnzzle

Cadet
Thread starter
Joined
Aug 11, 2017
Messages
6
Thanks guys! I have remove those 4 bolts on each side, what is the one nut in the rear you talking about, I am not sure where is it. Also the power head is loose now and I move it up and down but not coming off all the way.
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
In there very rear of the powerhead, accessible from underside, in a recessed area, you'll see a nut on a stud. Remove the nut... Half-inch head.
 

bjnzzle

Cadet
Thread starter
Joined
Aug 11, 2017
Messages
6
In there very rear of the powerhead, accessible from underside, in a recessed area, you'll see a nut on a stud. Remove the nut... Half-inch head.


Thanks again. I've attached the picture, is that stud sits in that red circle?
 

bjnzzle

Cadet
Thread starter
Joined
Aug 11, 2017
Messages
6
Ah that nut I already removed. Still really hard to pull up :(
 
Last edited:

175se

Petty Officer 1st Class
Joined
Mar 6, 2014
Messages
274
Maybe a dumb question here did you disconnect the shift rod?
 

bjnzzle

Cadet
Thread starter
Joined
Aug 11, 2017
Messages
6
Maybe a dumb question here did you disconnect the shift rod?


you're right, I did not disconnect the shift rod. According to the manual, I need to remove the screw holding the shift clevis to the shift rod, I am not sure where is that screw, any suggestion? Thanks!
 
Top