help re conecting shift linkage to lower unit

rfwj

Cadet
Thread starter
Joined
Nov 19, 2007
Messages
20
I have a 1997 115 Evinrude and I am trying to re connect the long shift pole to the linkage under the carb. The replacement lower unit is back on and bolted. I know there is a bolt I removed and I can't remember how to get that connected I have a bolt and the pin out.

Any advice or photo would be great. even a link to a picture.

thanks

rich
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
Shouldn't be a bolt involved with that motor. Should be a clevis pin that releases the shift arm. Then push the shift arm inwards to open the retainer pin, slide the shift rod into place, then pull the shift arm back out to close the retainer pin into the hole in the shift rod.
 

rfwj

Cadet
Thread starter
Joined
Nov 19, 2007
Messages
20
I think I removed a bolt. maybe I did not need to but I did. is there a link out there with a schematic?
 

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
Most of the OEM parts sites have diagrams. Iboats doesn't allow links to their competitors, but a google search ought to turn up what you need. Have your model number handy...
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,330
I have a similar motor. I find that the shift rod is snug in the midsection, and is pushed down, as I install the gearcase. I use a sharp screwdriver (or awl) to hook the end of the shift rod and pull it up. I still usually need to move the control to drop the shift linkage a bit to mate the shift rod and linkage. The shove the linkage over and install the clevis pin.

On my motor, the starter is no where near the shift linkage,
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,330
Well, you never seen my motor. The shift linkage is at 6 O'clock and the starter is at about 2:30, behind the intakes. You take the carbs off, you get more room as they are also at about 6 O'clock.
 
Top