Liamfjortoft
Recruit
Thread starter- Joined
- Jul 31, 2017
- Messages
- 4
I have an old 1961 18hp evinrude outboard 15034 that has been sitting in a garage for about 5-6 years. I have done a bit of work on it such as changing the spark plugs, stripped and cleaned the carburetor etc. After cleaning the contacts on the starter the engine fires up and continues to fire up first time. But, after around 40-60 seconds of running the revs increase and the engine cuts out. I am not 100% sure if this is an engine problem or my lack of knowledge on the general operation of the motor in terms of carburetor adjustment screws for low and high speed and tiller controls. Any advice is greatly appreciated thanks.
Last edited: