bluestreak3599
Cadet
- Joined
- Jun 23, 2011
- Messages
- 6
need help trying to figure this out...changed out my fuel cell, cause it was bad and motor wouldnt start..that fixed that problem and it started and ran good. pressure was good too at idle and revved up..brought it out today and ran it for about 5min. and it bogged dwn or missed once i got it planed out...then i noticed a little smoke, not much and my temp. guage was at 200 degrees...i killed the engine and opened the compartment and noticed my flush cap wasnt screwed ln right...i fixxed it and let it cool off for a while, then cranked up and tryed again, but the temp. rose to 200 again so we brought it back to the ramp...it did start running bad while tryin to load it up and it died also...just getting real frustrated with it and needing any advice ppossible. thnx