Grease between starter and drive assembly?

Dzp111

Recruit
Thread starter
Joined
Aug 14, 2017
Messages
4
Re.: 1966 60hp V-4

(Main starter equipped with starter drive on top)

I had to replace the shaft in the starter drive. Upon removal I noticed lots(!) of grease under it where it sits on starter. When re-installing it I followed instructions in my Seloc manual (it's been good to me). There is no mention of adding grease to any part. It does instruct to dab a little oil on top of the drive then continues with: "The remainder of the components will be assembled DRY. Do not use any oil or lubricant on any of the other parts."

There is no mention of grease in the starter motor section of the book either.

So I'm wondering what some of you do. Do you add grease in between the starter and the drive?

Thanks.
 

gm280

Supreme Mariner
Joined
Jun 26, 2011
Messages
14,605
:welcome: to iboats Dzp111. Glad you joined us ...

I would follow the manual. BUT, I usually apply a very thin (finger smear) of lube on such things myself and never had any issues. BUT I am sure others will chime in with their recommendations, and then you can choose what you want to do. JMHO
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
If you're talking about the bendix, I usually apply a drop or two of 3-in-1 oil. That's all.
 

Dzp111

Recruit
Thread starter
Joined
Aug 14, 2017
Messages
4
Thanks. Not sure what whoever assembled it last was thinking, I swear there was nearly 1/4 cup of grease there.

Could that have been the reason for my having to replace the starter motor and the gear shaft in the drive?
 
Top