Fuse

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Too aid diagnosis I get a little circuit breaker and wire two spades on it. Put in place of fuse. Disconnect everything I can and then plug back in one at a time to figure what circuit the short is in. Trim and tilt, start solenoid, wire harness, etc...
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
I used to use an amp meter. That way I could keep an eye on what was going on.
 

Crosbyman

Admiral
Joined
Nov 5, 2006
Messages
6,298
amp meter will allow high current flow and things and wires to burn up...while showing the amperage is high !!!

disconnect all loads first !!!
 
Top