Fuel Sender

Farm Guy

Recruit
Thread starter
Joined
Jul 29, 2008
Messages
2
My Fuel Gauge Reads (not the right levels) when the key is not in the ignition, when I put the Key in and turn it to the alt or on position my fuel Gauge does not read. Is this a sender issue or a gauge issue. I disconnected the wire to the current sender when the key was not in and the level of on the gauge did not change. Appreciate your help. Thanks
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Fuel Sender

You have a wiring issue. The gauge should not have power on the +12V line with the key in the OFF postion. It should only be active in the RUN position.
 

Farm Guy

Recruit
Thread starter
Joined
Jul 29, 2008
Messages
2
Re: Fuel Sender

Thanks Silvertip, from what i see positive and negative run from the sender to the gauge, there is a jumper that goes to the next gauge and another that I would guess is a positive from the ignition to the gauges but that is a guess as i though it was the sender and didn't investigate that to much. Where do you think the issue is, a short from the ignition to the gauge?
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Fuel Sender

There should be one wire running from the sender to the gauge. That wire connects to the "S" (sender) terminal on the gauge -- it DOES NOT connect to the +12V terminal. The ground wire from the gauge may or may not run to the gauge. If it does, it must connect to the "-" (negative) terminal on the gauge, or to the ground buss on the fuse panel. It does not have to run to the front at all -- instead it can be connected directly to the negative terminal of the battery since it is generally right next door. The +12V and ground terminals on the gauge are typically daisy chained from one gauge to the next. The +12V feed to any gauge must only be active with the key in the RUN position. Shorts blow fuses so you do not have a short. Miss wired is the probable cause.
 
Top