fuel mixture and park plugs

codyrenken

Recruit
Thread starter
Joined
Jun 6, 2003
Messages
1
I have a Johnson 5 1/2 hp model#CDL-20R. I was wondering what the fuel/oil mixture should be. Also I would like to Know the year and correct spark plug #
 

JB

Honorary Moderator Emeritus
Joined
Mar 25, 2001
Messages
45,907
Re: fuel mixture and park plugs

Hi, Cody.<br /><br />Your engine is a 1963. The recommended plug at the time was the Champion J4J, gapped at .040.<br /><br />I think the modern replacement plug is a J4C.<br /><br />OMC called for a 24:1 mix for fuel. TC-W3 rated oil and 87 octane unleaded regular. Avoid gas with alcohol.<br /><br />For extended use at low rpm you might use a J6C plug at .030 to .040 and a 32:1 mix. If you plan to run at high speeds, use the 24:1 mix and the J4C plug.<br /><br />Good luck. :)
 

seahorse5

Rear Admiral
Joined
Jan 24, 2002
Messages
4,698
Re: fuel mixture and park plugs

The original recommended plug gap was .025".
 

JB

Honorary Moderator Emeritus
Joined
Mar 25, 2001
Messages
45,907
Re: fuel mixture and park plugs

I don't know where you got that, Seahorse. At .025 they foul awfully easy on 24:1 mix.<br /><br />Johnson Motors Service Manual, page 78: J4J, .030<br /><br />Glenn's Johnson Outboard Motor Repair Manual and Tune-up Guide, page 42.: J4J, .030<br /><br />Both manuals are circa mid 60s and cover all Johnnys made to that time.<br /><br />OMC later recommended .040 for all plugs in that era. That is what Joe Reeves recommends. They are harder to foul that way but need regapping more often than when set at .030.<br /><br />Generally, on the CD and FD series engines I prefer to use the larger, .040 gap on hotter (J6J) plugs for trolling and putting about, and the colder, J4J plug with the .030 gap for long runs at higher speeds.
 
Top