Fuel Gauge dead - need sender specs, advice...

Ken C

Recruit
Thread starter
Joined
Aug 4, 2008
Messages
1
I've got a 1989 SeaRay 200 CC (205hp 4.3 with alpha one). I haven't been able to use the boat since last summer, and now when I was getting it ready (a late start) I discovered the fuel gauge seems dead! It's pegged on the bottom (below Empty). Usually when I turn the ignition key (not to start, just to 'on'), all the gauges "jerk" to their settings, but not the fuel gauge. I know the tank is full - besides using storage chemical last fall, I just took it to refuel and was only able to put in 1.8 gallons.
I'd like to determine whether it's the sender or the gauge itself: assuming it's like a car's wiring (the sender grounds through a variable resistor), what would be the ohms from the wire (at the gauge) through the sender at full if the sender is good? How else can I check the gauge, e.g., ground the gauge's sender terminal -- would it go to full or empty?
Any other suggestions are welcome...
 
Top