fuel flow restriction problem

firehntr92

Recruit
Thread starter
Joined
Jul 15, 2003
Messages
2
I have a 1990 Evinrude 175hp VRO that is having problems with fuel flow restrictions. But only sometimes. With the problem the engine will run at about half throtle and then cuts and misses badly. This whole time the fuel flow warning alarm is sounding. For some reason the fuel primer bulb will not stay hard, i have replaced it twice and still doesnt correct the problem. My question, is this a mechnical problem or a procedual problem as far as am i not doing something right when i start the boat. I have been told that i should not have to pump the primer bulb each time i start the boat is this true. Any advice would be greatly appreciated.
 

rabidfish

Senior Chief Petty Officer
Joined
Oct 3, 2000
Messages
788
Re: fuel flow restriction problem

Once you have run the engine for a few minutes, you should not have to squeeze the primer bulb again.... <br /><br />As for the fuel warning horn, have you confirmed this? ( if you disconnect the wire to the vaccum switch does the horn quit?)<br /><br />If so... attach a portable fuel tank(like for a small outboard) directly to the engine. Does this solve the problem? <br /><br />if yes, then the problem lies in the supply system in the boat ( fuel tank pick-up tube / anti-siphon valve / fuel hose / primer bulb / equipment laying on the hose(batteries etc... ))<br /><br />if the problem persists... then you have a problem on the engine( kinked hose / fuel filter / etc... )<br /><br />Also make sure all the hose has an I.D. of 3/8 inch. This is recommended per johnson/evinrude<br /><br />Make certain this is not an overheat problem. The warning system is designed to slow the engine if an overheat occurs. ( it runs 2200 +or- rpms, but misses horribly when you try to run it harder than that. )
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: fuel flow restriction problem

On initial startup pump primer bulb until firm.After engine has been run and shut off for a spell it doesn't hurt repriming the bulb until firm again as long as the carb float valves are seating properly.If your bulb goes soft or tends to colapse while running it is indicative of a fuel restriction upstrem of the bulb.Check tank pickup tube strainer and insure tank vent is open.<br /><br />Have you tried pumping the primer bulb when engine is cutting out and see if it picks up?
 

firehntr92

Recruit
Thread starter
Joined
Jul 15, 2003
Messages
2
Re: fuel flow restriction problem

I have found out that it was a check valve in the gas tank. Thanks for all the help anyway. Matt
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: fuel flow restriction problem

That's a fuel restriction upstream of the primer bulb. ;)
 
Top