Fuel Dripping From The Carbs When It's Hot Out - 200HP Johnson 2001

[Scode68]

See post #5 on the torque value !

Yeah, but where did you get this from?

 

[racerone]

A well respected / long time ( 35 years ) Evinrude dealer.-----But many folks are doubtful of some knowledge shared here.

 

[Scode68]

A well respected / long time ( 35 years ) Evinrude dealer.-----But many folks are doubtful of some knowledge shared here.

Should have said where you got the information from. I’m not on here to disrespect anyone here but if I don’t have all the information I can’t make the decision.

 

[Faztbullet]

Information from factory manual

 

[jonesg]

Check the carburetor bowls.-----If they have not been replaced they are likely warped.----Take note of jets should you need to replace them.----Torque on the screws is 10 inch lbs I believe.

this.
theres too many wags , expert opinions get swamped.