Few Q's regarding 3.0L HO I-4 OMC

LabradorBoy

Cadet
Thread starter
Joined
Jun 11, 2004
Messages
13
Hi guys, I'm new to the board and after reading some of the posts in this section of the forum, I'm a little weary of my sterndrive...the 1991 Ford 3.0L I-4 I have in my boat seems to be one of the more problematic engines out there :( <br /><br />Mine has been good so far, I just have two issues with it:<br /><br />1) I have a problem getting the engine to idle correctly. I often have trouble getting the engine to idle long enough for me to be able to go to neutral, stop, then try to engage forward gear. I plan to change the plugs/filters/oil and clean the throttle body before I launch again soon, but does anybody else have any suggestioons as to what I should do here?<br /><br /><br />2) I have a lot of grinding when trying to engage forward gear, it seems that the engine is not quite in gear by the time the engine is already starting to rev up a bit. Would I be right to assume that there is turnbuckle-style cable adjuster behind my control console that I can "tighten up" in order to engage forward gear a little sooner?<br /><br />Please forgive me if these are newbie questions, but this is a problem that had annoyed my Dad for a while and I'd like to be able to solve it.<br /><br />Thanks!<br /><br />-Rob<br />robpilgrim@hotmail.com
 

Mercathode

Petty Officer 1st Class
Joined
Jun 8, 2004
Messages
210
Re: Few Q's regarding 3.0L HO I-4 OMC

Hi LabradorBoy<br />The egine that you describe is a more than likely a Chevy I-4. Sounds like you carb may need some adjustment as well as your throttle and shift cable linkage.
 

LabradorBoy

Cadet
Thread starter
Joined
Jun 11, 2004
Messages
13
Re: Few Q's regarding 3.0L HO I-4 OMC

Thanks for the reply 954Winns, it could very well be a Chevy engine, but from what I recall, it was a Ford. I could very well be mistaken though, so I'll have to check when I get back in town. The engine is mated to an OMC Cobra stern drive and is actually the "HO" version of the 3.0L, if that makes any difference.<br /><br />I will definitely be making some carb/throttle/shift linkage adjustments this summer.<br /><br />-Rob
 
Top