Failure to perform

jk2alphabravo

Recruit
Thread starter
Joined
Jun 6, 2003
Messages
2
I have a 1992 johnson 90 outboard. Idels great,however when applying power to get up on step engine boggs down. If I push in on electric choke,while bogged down at full throttle, Boat takes off like a rocket ship and when I realese choke boat runs great untill I slow down then I have to repeat process to plane. Any solution?
 

ob

Admiral
Joined
Aug 16, 2002
Messages
6,992
Re: Failure to perform

Sounds like a fuel restriction in carburetor fixed orifices or porting.This will require removal of the carbs and cleaning or rebuilding.This is assuming that the carb linkage is not out of adjustment causing them to open late in relation to ignition timing.Good luck.
 

jk2alphabravo

Recruit
Thread starter
Joined
Jun 6, 2003
Messages
2
Re: Failure to perform

Thank you for the confirmation. Would you recomend the Marvel Mystery Oil or Kano mix with some gas to remove varnish and gum? Or just take them apart and clean it anyway. Also what is the tell-tale sighns about primer bulbs. soft verses hard and what it means.
 

sharkcat

Petty Officer 1st Class
Joined
May 4, 2003
Messages
285
Re: Failure to perform

Hmm failure to perform...soft vs hard..try viagra.Sorry couldnt resist it :D :D :D <br />I havent had much sucess with fuel additives to clean out blockages.The best way is to strip carbs,clean,blow thru all passages with compressed air if available,reset float levels,reassemble with new gaskets if the old ones are hard or damaged.Refit to engine & do a link & synch.Then adjust idle screws with the engine running in gear in the water.As far as fuel bulbs go I have 2 merc 60s on my boat on 1 the bulb stays firm & the other requires 2 pumps too make it firm with the engine running yet they both run fine :confused: Im not if it aint broke dont mess with it.Good luck :)
 

tobolamr

Cadet
Joined
Jul 31, 2003
Messages
22
Re: Failure to perform

I know it's an old topic, and I'm a new poster...<br /><br />I had similar troubles on my old 18hp Evinrude. We ran a few bottles of some stuff called Sea Foam through it before trying to rebuild the carb. The Sea Foam helped tremendously! The motor runs great now, and there are very few engine issues one year later.<br /><br />The carb rebuild kit? I still have it... unopened ;) <br /><br />I found Sea Foam at a local shop called Fleet Farm. I think they also sell it at like Checker Auto and other large auto parts stores.
 

Dhadley

Supreme Mariner
Joined
Feb 4, 2001
Messages
16,978
Re: Failure to perform

Keep in mind that on motors with multiple carbs and / or throats, that is a certian cylinder isnt gettin fuel, guess what? Its not getting oil either. Aluminum pistons need the oil. So while youre trying to "run it clean" it may...........<br /><br />Just something to ponder!
 
Top