Evinrude Tachometer issue

ED7189

Recruit
Thread starter
Joined
Apr 25, 2018
Messages
2
I had a 1999 Evinrude 150 that had engine issues so I bought a 2012 Etec 150 and had an Evinrude mechanic switch it out on my boat. The problem is now is the tachometer runs on the high side. Meaning that it reads 7000 rpm but I'm only going 40 mph. What is wrong? At 7000 rpm the rev limiter should be kicking in and if it was going at 7000 rpm I should be flying across the water at 70 mph not 40. Any suggestions?....Thanks
 

alldodge

Moderator
Staff member
Joined
Mar 8, 2009
Messages
44,770
Normally there will be a switch(s) on the back of the tach. It needs to be changed to match your new motor. The Evinrude Mech should have changed it to match. What brand of tach do you have?

Found on another forum that the Etec uses a 6 pulse system, and some tachs list it as 12 pole
 

ED7189

Recruit
Thread starter
Joined
Apr 25, 2018
Messages
2
It doesn't say a brand on it, but it is on a Triton Bass boat
 

alldodge

Moderator
Staff member
Joined
Mar 8, 2009
Messages
44,770
Look on the back of it for the switch, usually a rotary type with numbers marked on it
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Mechanic should have checked that, I would say -- might bring it back to him.

agree with AllDodge's suggestions. Might also check to be sure the battery is charging.
 
Top