evinrude sportwin

[tggarvey]

My out board is I believe a 1968 9.5<br />It starts ok and seems to work fine for any lenght of time until I turn it of then it sometimes takes half hour of pulling to restart<br />I have blisters on my hands. Can any one tell me why ?

 

[Solittle]

Re: evinrude sportwin

Welcome tom - - <br /><br />It won't start till it has the right amount of fuel, air & spark in the cylinder goin off at the right time. What have you done to troubleshoot it?

 

[tggarvey]

Re: evinrude sportwin

Im not very good with engines<br />I just keep pulling and eventually<br />it starts when its cold it starts<br />easily even after the winter after two or three pulls but after running no luck

 

[davemaxi1970]

Re: evinrude sportwin

Is it pumping enough water? it may be getting to hot everything expands compression lowers and it wont start till it cools down also try and strip and clean the carb

 

[tggarvey]

Re: evinrude sportwin

Thanks David<br />How do i know if its pumping enough water?<br />By the way im originally from Galway in IRELAND

 

[NEPA9.5E]

Re: evinrude sportwin

Hello I have a 1972 Evinrude Sportwin 9.5 (model 9222m). I bought a new fuel line and tank as well as plugs wires and fuel lines. At any rate I put it in a test tank and it runs great, until it place the lid on, then it bogs down just above an idle with little power, I did observe some of the foam loose and took it out just so it could not block the intake. I also drilled 3 3/8th holes inside and under the lid handle with no change in the problem. I search the site for this topic on this engine and didn?t find anything, but any direction, advice or help would be great, thank you in advance.