Evinrude Ocean Pro 150

Znarffsu

Recruit
Thread starter
Joined
Aug 8, 2003
Messages
5
A few weeks back my boat felt like I hit something as I was running out to the Gulf. The motor then immediately died. After trying for a few seconds is started back up and was running fine. About 10min later it did it again. It felt like I was running over rocks and then it died. Again it started back up and ran fine. I then ran her full out at 48mph and had no problems. For the past 2 days I tried to recreate the problem on the lake. She starts great, runs great down the canal, then when I hit the lake and punch it, it feels just like im hitting something and she dies. Starts back up and runs fine. <br /><br />Someone suggested that I take off the black and yellow wire from the ignition switch to see if I have a faulty key switch. This did not fix the problem.<br /><br />Today the problem happened again as I punched it for the first time.. It did it twice then no more problems except for one single slight miss at full speed.<br /><br />Could this be a power pack? Any suggestions?
 

clanton

Rear Admiral
Joined
Jul 9, 2001
Messages
4,876
Re: Evinrude Ocean Pro 150

It does not sound like a gearcase,but I would change the gear oil and check for metal. The coils arc to the metal plate that covers the power pack, if its arcing you can see the arc and the burnt spot on the plate. Without test results, I guess powerpack and sensor, new pack comes with sensor. You can verify this with peak reading meter, long test leads, connected to pack output to coil, check each cylinder, each time the cylinders misfires the meter will dip. You will need to put boat in water, run at full throttle.
 
Top