Evinrude has its own mind ?

Schleissheimer

Recruit
Thread starter
Joined
Aug 9, 2016
Messages
2
have a Carolina skiff with a 2007 Evinrude E-Tec 115 on it. While out fishing in the ocean the motor tilted all the way up on its own . It would not go back down. The tilt switch is on the engine itself. Trim on the throttle.
What could cause that and is there a manual trick to lower the engine again ? Thanks for any help .
 

boobie

Supreme Mariner
Joined
Nov 5, 2009
Messages
20,826
Yes. Open up the manual release valve on the side of tilt unit itself. Could be one of the t/t switches on the motor or the control handle is bad.
 

Schleissheimer

Recruit
Thread starter
Joined
Aug 9, 2016
Messages
2
ok. Thank you so much. I will check it out. If I open up the release valve will it leak ?
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Does the trim motor continue to run once it has tilted fully on it own?

I would tend to think you have a bad switch or two because yhe relays on these etecs are in a sealed little box and have proven reliable. I have only replaced one and that was warrantie on a brand new one.

You could also check for corrosion on the wire connectors.
 
Top