evinrude fisherman 6hp flywheel question

powerprop

Recruit
Thread starter
Joined
Apr 21, 2016
Messages
1
Hello all,
I just bought a evinrude fisherman 6hp outboard motor (1970). At purchase, the motor had no spark on the top cylindre (not a big deal for me, I know how to diagnose and repair and the price was quite low.
Yesterday, I started the repair and discovered something that I missed on purchase... and I'm not proud of me on that one but that's another story. I found a broken flywheel... but just a little part of it is broken. To me it looks like the previous owner tried to remove the flywheel with a jaw puller and put the jaws on the wrong plate. so a little part from the top of the flywheel broke. The missing part is about 1 inch long, 1/4 large and 1/8 high. I'm trying to post picture of it. Do you guys think this will unbalance the motor enough to be dangerous for the upper crankshaft bearing or would you just put it back there the way it is?
 

Attachments

  • 20160421_074454[1].jpg
    20160421_074454[1].jpg
    215.8 KB · Views: 0
Last edited:

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Been there, seen that. In theory, it would upset the balance, but just how much is in question. If it really bothers you, you could grind out a piece on the opposite side. You won't get it perfect, but closer than it is now.
 

sutor623

Rear Admiral
Joined
May 23, 2011
Messages
4,089
Technically it will be off balance but I doubt you would notice any difference with a piece that small being broken off. You can always start it up and see if it is shaking violently or if it seems smooth.
Now if this was a 200hp that you had a couple G's sunk into id say change it, no doubt.
 
Top