FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Ok i just found out the kill-switch is making probs. Dusconnected the main plug and jump started it,and it started right up. Can i just cut the two leaders going onto the kill-switch?
Key switch is new,and was also used in previous control box.i cut the one to kill switch and motor runs great. But when stopping it,it must be primed,its ok,not a prob. Many thanks for helping me out once again,you guys are awsom
It does not stop on choke when warm,i had to disconnect fuelhose,even then it run long after. I can use a regular on and off switch to replace the original kill switch right?
you have a ground issue. the key switch should ground out your powerpack when you switch it off. you can use a toggle switch but it sounds like you clipped the wrong wire somewhere.
