Evinrude Alarm Issues

harmlouis

Recruit
Thread starter
Joined
May 29, 2016
Messages
2
I just bought a 1998 jet boat with a 115 OMC Crossflow. I use mixed gas as I understand this boat never had a VRO oil injection system. The alarm buzzer had been disconnected. Concerned about engine overheat, I hooked it back up. The buzzer now gives me a pulsed signal (low oil ?) when I pull away from the dock. The running engine temp is at 140-150 . (infrared thermo gun). In the driveway, when I ground the tan/black wire The buzzer give me a constant tone. (as it should for overheat ?)
I would like to ensure that I have temperature warning but what could be setting off the low oil signaL ?
 
Last edited:

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The VRO pump was installed inside a metal container to catch any leakage.-----This outboard powerhead has to follow " inboard " coast guard rules.----What type of pump does it have now ??
 
Last edited:

harmlouis

Recruit
Thread starter
Joined
May 29, 2016
Messages
2
This boat has no oil tank or VRO pump that I am aware of. It is a Four Winns Fling and I have been told that the VRO system was not used in 1998
 

jakedaawg

Rear Admiral
Joined
Jun 26, 2012
Messages
4,275
Yes, the vro was used. As racer said its in a metal can. The can is on the front right of where the motor is. The oil tank was usually on the left. For that signal to beep it is probably still there or you have a buzzer going bad
 
Top