EVINRUDE 6HP POWER LOSS

BASSMASTERJ

Recruit
Thread starter
Joined
Aug 5, 2003
Messages
2
I am having trouble with my early 80's Evinrude 6hp outboard and was wondering if anyone could offer some advice. The motor seems to run rough and not achieve full power. When I unplug the fuel line from the motor, after a few seconds it will get up to full speed. When I plug the fuel line back in, it starts going slow again. I have replaced the fuel line thinking that was the problem, but it continues to do this, can anyone help?
 

motwerf

Cadet
Joined
Aug 3, 2003
Messages
7
Re: EVINRUDE 6HP POWER LOSS

have you had the carb apart? <br />stuck open float? <br />will it idle? correctly?<br /><br />did you replace all the lines from the Quick- connect to the pump and then to the carb? I recommend clear line so you can actually see the fuel flow, a;so allows for observing air leaks.<br /><br />are you useing a gas stabilizer over winter? <br />are you using a premium 2 cycle oil? I use Opti 2 - pricy though but it is much better than the others, in my opinion after reading their web site, includes a stabilizer.<br />are you using premium fuel? <br />DID YOU START WITH A NEW BATCH OF GAS?<br /><br />Just a few things to think about
 

BASSMASTERJ

Recruit
Thread starter
Joined
Aug 5, 2003
Messages
2
Re: EVINRUDE 6HP POWER LOSS

Thanks for your reply, I have not checked the carb at all. I am assuming the problem exist between the quick-connect at the motor and the gas tank. Like I said if I unplug the gas line while running it will jump up to full speed. Once it burns up all the fuel and I reconnect the fuel line, then it starts running weak and slow again. The motor runs fine at idle speed, except for smoking slightly which may be normal. I have replaced the fuel line already, as I initially thought it was do to a leak. I have been through multiple tanks of gas (regular unleaded)and have been using TC-W3 motor oil that is specifically for outboards. Up to about a month ago the motor would always achieve full speed and run fine this all occured after a refueling. It really has me stumped.
 

motwerf

Cadet
Joined
Aug 3, 2003
Messages
7
Re: EVINRUDE 6HP POWER LOSS

The part where it runs fine after disconnect is strange<br /><br />I would be suspecting a bad batch of gas if this all started suddenly after a refueling. Does the place of purchase go through al lot of gas or did you fill up just before or after they had their tank filled Water in the gas maybe? <br /><br />I know 2 strokes do not like methyl alcohol but..... alternatively dump ALL the gas into a large glass jar or something you can see into and look for water on the bottom after a few minutes settling time. keep it capped while waiting, vaporized gas is dangerous.<br /><br />cheers
 

Xcusme

Commander
Joined
Apr 21, 2003
Messages
2,888
Re: EVINRUDE 6HP POWER LOSS

Bass,<br />Sounds like a carb rebuild is your next step. Pay attention to the float valve and high speed circuit.. Looks like your motor is getting too much fuel. Manuals are readily available at the link at the bottom of this page. If your carb has a high speed adjustment knob, turn clockwise until lightly seated and then open 3/4 turns for an initial setting. I kinnda think you may have a fixed high speed jet, in this case, the carb rebuild , with new gaskets, should get you going.
 
Top