Markjmorris70
Recruit
- Joined
- May 31, 2009
- Messages
- 3
I have a 1997 50 hp 2 cylinder engine that will not start. It has been standing since last season, ie September
i initially had probelms getting fuel through but stripped down the VRO and pumped fuel through to clear a blockage
I tried to start the engine with the inlet manifold not fitted and it woudl not start, however I put my hand over the top carbs inlet to check for suction and the engine fired up and revved really high, despite being in neutral and with the choke on.
I will fit the inlet manifold tomorrow but there is a tube coming off the bottom right hand side of the manifild and I can't see where the other end should go to
Any ideas??
regards
Mark Morris
i initially had probelms getting fuel through but stripped down the VRO and pumped fuel through to clear a blockage
I tried to start the engine with the inlet manifold not fitted and it woudl not start, however I put my hand over the top carbs inlet to check for suction and the engine fired up and revved really high, despite being in neutral and with the choke on.
I will fit the inlet manifold tomorrow but there is a tube coming off the bottom right hand side of the manifild and I can't see where the other end should go to
Any ideas??
regards
Mark Morris
Last edited: