Evinrude 48 spl starts intermittently

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Just one last comment.-----The sensor coil directs the SCR switches in the powerpack to discharge the capacitor to the coils to fire at the right time.-----Points used to do that function in years gone by.----I believe the sensor coil is built into the powerpack on those where the powerpack is under the flywheel.
 

Crosbyman

Admiral
Joined
Nov 5, 2006
Messages
6,298
strange you say you have sparks but it does not start as if no fuel in the cyl to... fire it up
have you tried a squirt of fuel in the cylinders to see if it will start and run or just die when it is finished burning the fuel

if it dies it is almost like it is not sucking in it's fuel to stay running....


just a suggestion...seeing this is very intermittent as was my darn power pack on my Classic 50

it may be worthwhile to remove these components and verify all the wiring and polish up the connections incl ground straps if any

those SCR need to " open" on a pulse up to allow the charged capacitor to dump the charge into the step up coils firing the plugs.

without an oscilloscope or similar eqpt to check "pulses" it is kind of hard to see who/what is not doing it's job
but at least checking all the wiring (loose or corroded) will eliminate that possible contribution to your frustrating issue.

?? why was that goopy stuff put there anyway...it may be hiding something ??
 
Last edited:

juno pierrat

Petty Officer 1st Class
Joined
Dec 14, 2013
Messages
355
hi bt1280 . you may want to check your model number for 94 engine. parts break down for a 94 shows a different ignition setup with charge coil, ignition sensor, and stator under flywheel but power pack out side. I believe 89 to 93 was configured like yours. also if it is power pack giving problem CDI makes a conversion to get PP away form high heat under flywheel.

hope im not introducing a " confusion factor " into discussion if so ignore comment.

also like Crosbyman idea to spray fuel into carbs, that helped me once find a problem on my motor
 

BT1280

Cadet
Thread starter
Joined
Mar 28, 2018
Messages
12
It actually is a 1993. I accidentally typed 1994. Thanks.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
lost track. Did you actually measure spark yet? $10 open air adjustable tester. I would set it for about 1/2", and work back if necessary until you see sharp spark. Do the test with both plugs removed as you need the rpm. You need to spin at about 200 rpm (or more). Charge the battery, sandpaper the connections (start with the battery connections), take apart the starter and at least clean it if that's what it takes -- may need new brushes.
 
Top