Evinrude 40hp VRO

Arcobaleno

Recruit
Thread starter
Joined
Jul 17, 2016
Messages
3
Hello,

Last year i bought a second hand 40hp 2stroke outboard engine. (E40ELCU) As a newby the motor sounds good when demonstrated, but now a year later it hasn't run one moment like it should be...
In the meantime the VRO pump is replaced with a normal fuelpump and the carbs should be adjusted as well. (Just brought the engine to a repairshop and there it was running quit well in a barrel of water)
Now i am on holliday and wanted to use the boat, we found out that there is still a problem:
Motor starts, seems to be running fine, but after a short time full power, it only runs at less then half speed.
After ruling out the fuelfilter (just connected the hose directly) just put up a new test and found out that the motor starts to perform 100% better when i push 1 time the electrical primer... (Not indefinitely, but quite a while)
My conclusion is that it has too less fuel: am i right?
Or is it just the other way around?
After reading some topics i was thinking of checking the highspeed jet....
Can someone please put me on the right track?
Thanks anyway!
 
Last edited:

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
You need to clean the carburetors.------Make sure you clean the high speed jets.-----They are about 5/8" long and screwed into the carburetor bowl.
 

Arcobaleno

Recruit
Thread starter
Joined
Jul 17, 2016
Messages
3
Thanks for the answer. I will certainly do that. Because of some stories i read about wrong size jets, i will also try to figure out if i have the correct ones....
 

Arcobaleno

Recruit
Thread starter
Joined
Jul 17, 2016
Messages
3
Just checked the jets: one was glogged and was only for less then 20% open...
The code on the jet = 38D, so if someone knows if that's the correct one...
Boat is now going like a rocket....
Thanks racerone for your advice!
 
Top