Evinrude 35 1977 - Ignition wiring - Help!

newbboater

Recruit
Thread starter
Joined
Aug 2, 2003
Messages
1
I have seen the wiring diagram below but I have some questions...<br /><br />1. My ignition switch has 4 poles which are not marked but I have determined what each does. Bat-Red, Solenoid-White. With these 2 connected the motor starts and runs. The other 2 poles... one is always hot and the other is hot when in the on position. This last one is accessory. Why is the one pole always hot?<br /><br />2. The most important question is I do not seem to have the Brown/White wire for the choke but I do have a purple/white. Is this the choke? is my choke only manual (there is a white choke knob on the motor). With the current wiring I have to have the choke knob pulled all the way out to start and run and when I get to 3/4 throttle it boggs and stalls. I do have a choke toggle on the dash from the previous motor. If the purple/white is a choke wire what is the complete circuit to the toggle (one pole to purple/white the other goes to ground or hot?) <br /><br />3. I ran the black wire to body ground but should it just be running it to a kill switch with Black/Yellow?<br /><br />B (Bat) = Red<br />C (Choke) = Brown/white stripe<br />A (Accessories) = Anything you want 12 volts applied to when the key is in the ON position.<br />S (Solenoid) = white<br />M (Magneto) = Black<br />M (Magneto) = Black/Yellow stripe<br /><br />Any help appreciated!
 

Hooty

Rear Admiral
Joined
Oct 2, 2001
Messages
4,496
Re: Evinrude 35 1977 - Ignition wiring - Help!

The black wire on the "M" terminal should be a ground wire. It grounds the magneto and kills the engine. All black wires are ground wires.<br /><br />c/6<br /><br />Hooty
 
Top