OMC_Rookie
Cadet
Thread starter- Joined
- Jan 4, 2016
- Messages
- 7
Hi guys, I've been a reader of this forum for some time however have only just gotten round to signing up.
Would like the opinion of those in the know as to whether I have an issue or not.
I'm concerned about the condition of the brass low speed needle housing (not sure if this is the correct term). It's basically the brass bush that the low speed needle is screwed toward in order to control the Air Fuel ratio at idle condition. The carburettor is a Type 'A' from a 1992 Evinrude 30hp.
Low speed idle quality has always been an issue and the ability to make much improvement with the low speed needle has been limited. It appears that the brass bush / housing in the photos attached has been worn? Or it could be the case that this is the shape of the factory part. I pulled down my old 25hp evinrude carb of similar year to inspect. The 25hp carb has a near perfect inner circle for air flow whereas the 30hp appears to have a gouge out of bush. Is this a factory difference between the two size outboards?
Happy boating
Would like the opinion of those in the know as to whether I have an issue or not.
I'm concerned about the condition of the brass low speed needle housing (not sure if this is the correct term). It's basically the brass bush that the low speed needle is screwed toward in order to control the Air Fuel ratio at idle condition. The carburettor is a Type 'A' from a 1992 Evinrude 30hp.
Low speed idle quality has always been an issue and the ability to make much improvement with the low speed needle has been limited. It appears that the brass bush / housing in the photos attached has been worn? Or it could be the case that this is the shape of the factory part. I pulled down my old 25hp evinrude carb of similar year to inspect. The 25hp carb has a near perfect inner circle for air flow whereas the 30hp appears to have a gouge out of bush. Is this a factory difference between the two size outboards?
Happy boating