Evinrude 15 HP, 1980, Stalling Problem

dbs842

Recruit
Thread starter
Joined
Jun 22, 2003
Messages
1
I'm having a problem keeping this engine running without squeezing the fuel bulb. The carb, fuel filter and fuel lines are clean. Sometimes it will idle ok for a while then stall. Will not run at high speed for more than 5 seconds unless the the gas is forced into the pump. Is the hole in the block between the fuel pump mounting holes supposd to push out air? When pulling on the started rope, it does not.<br />Also, any recommendation on a good repair manual will be greatly appreciated.<br /><br />Any suggestions?<br /><br />Thank you very much for any help you can offer.<br /><br />Dave S.
 

Fouled Plug

Ensign
Joined
Jun 29, 2001
Messages
935
Re: Evinrude 15 HP, 1980, Stalling Problem

I think your fuel pump diaphragm is due for a replacement. Squeezing the bulb to keep 'er running is a classic symptom of a bum pump.
 

skeets

Seaman
Joined
Apr 14, 2003
Messages
67
Re: Evinrude 15 HP, 1980, Stalling Problem

dbs842<br />Your local dealer can orderan OEM or go to the bottom of this page and click on manuals<br />good luck.
 
Top