Evinrude 15 bering carrier

thatone123

Banned
Thread starter
Joined
Mar 7, 2009
Messages
707
This is a very typical 80's 9.9/15 gear case in good condition. I had a time getting the old prop seal off, but got it off finally. I am familiar with these gear cases and have changed the prop seal before, but cannot get the carrier back in the gear case this time. I try without the reverse gear and also with the gear in the bearing cavity and then trying to line it up with the 2 protruding stubs on the face of the part you can see when you look at the forward inner part of the gear case. ???... FYI/BTW, I could not get the old seal off at all til I was going to try the old trick of drilling a hole to put a screw so to pull the old seal out. Lo and behold, by drilling on the old seal face after a while the seal actually starting to spin in its case. the gear case, and it came right out. This may help someone and worth a try.
 

Patrick M

Cadet
Joined
Jul 29, 2017
Messages
9
Half the time you have to pound them back in grab a flat driver don't hit the threads and gently tap it back in
 
Top