Evinrude 115 Tach Problems

COOLEY

Cadet
Thread starter
Joined
Jun 22, 2009
Messages
6
I Just Purchased A Boat W/ 1995 Evinrude 115 Intruded. At Idle The Tach Works And The Volt Gauge Is Pegged At 18+ Volts. At Acceleration The Tach Bottoms Out And The Volt Gauge Never Moves Unless You Put A Load On It Like The Tilt. Then It Flickers Slightly. Any Thought On This Issue. Any Help Would Be Great.
 

Joe Reeves

Supreme Mariner
Joined
Feb 24, 2002
Messages
13,262
Re: Evinrude 115 Tach Problems

(Testing Tachometer With Water Cooled Regulator/Rectifier)
(J. Reeves)

A quick check is to simply plug in a another new tachometer as a piece of test equipment. If the new tach works properly and the old tach didn't, obviously the old tach is faulty.... but usually boaters don't carry around a spare tach (see below).

A faulty rectifier wouldn't damage the tachometer, the tachometer simply wouldn't work. This is due to the fact that the tachometer operates off of the charging system and the rectifier converts AC voltage to DC voltage, enabling the charging system. A faulty rectifier disables the charging system, and the tachometer simply doesn't register.

However.... those water cooled regulator/rectifiers that are used on the 35 ampere charging systems (and some others) bring into play a different type problem, and as you've probably found out, they are really a pain to troubleshoot via the proper procedure. There's an easier way.

The tachometer sending/receiving setup operates off of the gray wire at the tachometer. That same gray wire exists at the engine wiring harness which is connected to the engine electrical terminal strip. You'll see that there is a gray wire leading from the regulator/rectifier to that terminal strip, and that there is another gray wire attached to it. That other gray wire is the wire leading to the tachometer which is the one you're looking for.

NOTE: For the later models that DO NOT incorporate a wiring terminal strip, splicing into the "Yellow Wire" mentioned will be necessary.

Remove that gray wire that leads to the tachometer. Now, find the two (2) yellow wires leading from the stator to that terminal strip. Hopefully one of them is either yellow/gray or is connected to a yellow/gray wire at the terminal strip. If so, connect the gray wire you removed previously to that yellow/gray terminal. Start the engine and check the tachometers operation, and if the tachometer operates as it should, then the regulator/rectifier is faulty and will require replacing. If the tachometer is still faulty, replace the tachometer.

If neither of the yellow wires from the stator is yellow/gray, and neither is attached to a yellow/gray wire, then attach that gray tachometer wire to either yellow stator wire, then the other yellow wire, checking the tachometer operation on both connections.

I've found this method to be a quick and efficient way of finding out which component is faulty.... the tachometer or the regulator/rectifier. It sounds drawn out but really only takes a very short time to run through. If the water cooled regulator/rectifier proves to be faulty, don't put off replacing it as they have been known to catch on fire with disastrous consequences.
 

COOLEY

Cadet
Thread starter
Joined
Jun 22, 2009
Messages
6
Re: Evinrude 115 Tach Problems

Is The Voltage Guage Hooked Up To The Rectifier Also. The Guage Is Pegged At Max Voltage The Minute You Turn The Key On. The Tach Works At Idle 800-950 Rpms But When Accel Any Faster The Rpm Guage Drops. I Tried That Test And When Unplugging The Gray And Purple Wire & Jupping Grey To Yellow And Gray No Tach. But Volt Guage Is Still Pegged. ?????????????????????
 

COOLEY

Cadet
Thread starter
Joined
Jun 22, 2009
Messages
6
Re: Evinrude 115 Tach Problems

If It Is The Rectifier Any Suggestions On Where To Purchased With Out Getting Ripped If. Any Body Know On How To Rebuild Them?????????????????????????
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,332
Re: Evinrude 115 Tach Problems

The rectifier and voltage regulator are a sealed one piece unit. They are avail aftermarket from places like ebasicpower.com and CDI Electronics. I doubt that it is rebuildable.
 

Joe Reeves

Supreme Mariner
Joined
Feb 24, 2002
Messages
13,262
Re: Evinrude 115 Tach Problems

You state "I Tried That Test And When Unplugging The Gray And Purple etc etc etc".

In the test I mentioned, I said nothing about unplugging the purple wire.
 

COOLEY

Cadet
Thread starter
Joined
Jun 22, 2009
Messages
6
Re: Evinrude 115 Tach Problems

Well I Tried The Test And No Tach So I Replaced The Tach With A New One. The Tach Would Only Get Up To 1450 Rpm Then Zero Out. So I Replaced The Rectifier Regulator And Same Thing .tach Works Up To Aprox 1450 Then Zeros Out. Any Other Suggestions. Thanks Dayne
 

Chris1956

Honorary Supreme Mariner
Joined
Mar 25, 2004
Messages
29,332
Re: Evinrude 115 Tach Problems

Strange thing. I would check your wiring (grey and purple wires) from the tach to the VR.
 
Top