Evinrude 112 SPL

gpetrant

Recruit
Thread starter
Joined
Jul 21, 2014
Messages
1
Motor is on a 24 ft pontoon boat. If the motor cover is removed it runs good. With the cover on it stalls at idling speed. This makes me think it's not getting enough air. Should there be any vent holes in the cover? The cover was painted by the previous owner but we don't see any vent holes. Am I on the right track with air issues?

​Thanks
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
No , you are not !-----Look into issues with plug wires shorting to the cowling latches.------Air intake is on the back of the cowling up top.
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
It's also possible that the powerhead base gasket is leaking exhaust into the cowling. An unusual failure, but it can happen. If too much smoke gets into the inside of the cowling, it will get sucked back into the carbs and that will affect running, idling. If the previous owner put masking tape over the cowl vents during the painting process (as mentioned in post #2) that can block fresh air from getting to the carbs.
 

emdsapmgr

Supreme Mariner
Joined
Dec 9, 2005
Messages
11,551
The earlier crossflows did draw fresh air from under the bottom carbs. That lower cowl was re-designed in later years.
 
Top