Engine issues

Capecoddre

Recruit
Thread starter
Joined
Jul 23, 2018
Messages
3
I recently purchased a bass boat that came with a 1978 85 Johnson the engine cranks but doesn't start now I did a big No-No and I lightly sprayed some starting fluid in the intake and it started right up .once it warmed up I cut it off and it started right up every time After it gets warm I think I might be having a choke issue any suggestions?
 

jbuote

Lieutenant Junior Grade
Joined
Aug 17, 2016
Messages
1,001
Hey there! :welcome:

What's the starting procedure you've been using when cold?
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
^^agree. Choke plate has to close tightly for cold starting, with throttle set at high idle.
 

Capecoddre

Recruit
Thread starter
Joined
Jul 23, 2018
Messages
3
I leave the shifter neutral there seems to be a push to choke with the key on the controls so I push it in and I go to crank it over and I just cranks never and never starts so I thought it was a choke issue so I took the engine cowl off and manually push the choke on and still nothing I thought it could have been the fuel so I drain the tank and replace it I thought it could have been the battery so I got a new one still nothing
 

jbuote

Lieutenant Junior Grade
Joined
Aug 17, 2016
Messages
1,001
To start it from cold, you should:

1) Open the tank vent (if not open already)
2) Squeeze primer bulb in line from tank to engine till firm.
3) Raise the fast Idle lever
4) Push key in for choke
5) (while pushing key in) turn to start.
6) Once it fires,release key and choke. You may need to bump the key in a time or two for choke if it wants to die till it warms up a little.

Using ALL the steps above, it should start.

You can use the manual choke, but as noted above, you should check operation of the choke with the key.
 

Capecoddre

Recruit
Thread starter
Joined
Jul 23, 2018
Messages
3
So I finally got the motor to start without any other additives it took a while of me cranking on and off waiting into minute periods for the starter to cool off eventually it got warm enough and it started I tried using the manual choke and that seemed to do nothing and I noticed the electric choke solenoid is broken so maybe a carb repair kit and some choke Parts would do the trick
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
If it starts using the ether, sounds like you have spark -- so will mention the choke again. The choke plates have to close tightly on those engines, and they usually start pretty well. You seem to have linkage issues, and you might need to remove the air horn, reach in with your finger to make sure the plate closes. Do that using the manual choke (engine not running).
 
Top