[FONT=Verdana, Arial, Tahoma, Calibri, Geneva, sans-serif]I Purchased a used 87 Startos Bass Boat with an 87 Evinrude 140 V4 VRO (VRO disconnected). It was a freaking mess, I have had to rewire the whole boat. I am now tackling the engine issue. I've been having problems with the hole shot, it will not rev up to speed it bogs down. If the throttle is slowly increased, it will gradually build up speed. Once up on a plane, I can run 42 to 43 mph (GPS). The hole shot just bogs down. If I press the choke while trying to do a hole shot it just bogs the engine down worse. So it does not seem to be a fuel supply issue. Compression is 130 on all cylinders. Fuel filter is new. spark plugs and coil packs seem to be okay.
Following some of the threads here I took the cover off of the carburetors to check the jets. This is what I found. The intermediate orifice on the two carburetors on the starboard side of the engine were blocked off with a philips head screw. I am going to bet that this is not correct. The other two carburetors on the port side had a #16 jet in the intermediate orifice and all four carbs had #28 idle jet. Besides the no hole shot, the idle is very rough and I have no more adjustment in the screw to raise the idle. On a plane, it runs great, no issues at all.
I went to look up jets for the intermediate orifice and there are at least four sizes listed. 20, 32, 16, 42 and 45. Do I go with 16, since 16 is what the other carbs have?
As for the idle, if I replace the #28 idle jet with a #20, how will it effect the idle, will it go up or down?
Thanks for the help[/FONT]
Following some of the threads here I took the cover off of the carburetors to check the jets. This is what I found. The intermediate orifice on the two carburetors on the starboard side of the engine were blocked off with a philips head screw. I am going to bet that this is not correct. The other two carburetors on the port side had a #16 jet in the intermediate orifice and all four carbs had #28 idle jet. Besides the no hole shot, the idle is very rough and I have no more adjustment in the screw to raise the idle. On a plane, it runs great, no issues at all.
I went to look up jets for the intermediate orifice and there are at least four sizes listed. 20, 32, 16, 42 and 45. Do I go with 16, since 16 is what the other carbs have?
As for the idle, if I replace the #28 idle jet with a #20, how will it effect the idle, will it go up or down?
Thanks for the help[/FONT]