Elan 35

reddwarfau

Cadet
Thread starter
Joined
Mar 30, 2014
Messages
8
I have a 35hp Evinrude Elan, never been a problem for years. Overheated, and has been a problem since. Had serviced and gearbox checked. Now when taking off it will run smooth for a while then take off uncontrollable. Evenually the motor shudders and shakes and slows down like it has dropped a piston, but will then run for hours OK. I had a quick look at the motor and found the air silencer was not on properly and the little hose on the bottom had come off ( still haven't figured out how to get back on). I also noticed that a lot off small hoses were melted, not sue if they were for the oil injection which has been removed. Any ideas. I have been looking for some really good close ups of the motor with no success
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Not many folks are familiar with an " ELAN " model.--------Post a model # to get help.
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
The wee hoses are for the oil recirculation system.--They must be replaced-----Note ---That is NOT the same as oil injection.-----So test the compression.---Check for strong spark on all leads.----Was water pump replaced after the overheat ?---Was thermostat inspected ?
 

reddwarfau

Cadet
Thread starter
Joined
Mar 30, 2014
Messages
8
No Title

This was the first Problem, no matter what type of tool I use I cant get this on.
 

Attachments

  • photo239563.jpg
    photo239563.jpg
    46.4 KB · Views: 0
  • photo239564.jpg
    photo239564.jpg
    45.4 KB · Views: 0

reddwarfau

Cadet
Thread starter
Joined
Mar 30, 2014
Messages
8
No Title

Just to check, are these the hoses that need replacing. All were missing or melted. The water pump was replaced and thermostat checked. Where would I find a pict as to how the hoses went. Thanks
 

Attachments

  • photo239565.jpg
    photo239565.jpg
    55.6 KB · Views: 0
  • photo239566.jpg
    photo239566.jpg
    51.6 KB · Views: 0
Last edited:

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Yes those are the wee hoses that must be re-installed.----Not sure why you are having trouble with the hose from air box to the block.---Note------ I own more than one of these 3 cylinder motors.
 

reddwarfau

Cadet
Thread starter
Joined
Mar 30, 2014
Messages
8
It must be me, I cant get a tool in as I'm putting the air box back to push hose on.
 

reddwarfau

Cadet
Thread starter
Joined
Mar 30, 2014
Messages
8
Because most of the hoses were missing and or melted, I have no Idea where they go, I don't have a repair manual yet, anyone know where I can gets picts as to where they fit. Thanks
 
Top