E70TLEOR WOT timing

Buddy1263

Recruit
Thread starter
Joined
Jul 2, 2018
Messages
5
I replaced the timer base on a 70 hp Evinrude this weekend and when trying to set the WOT timing at 17 degrees as printed on the carb cover I could only get to 20 degrees before running out of threads on the adjustment screw under the flywheel. I set while going down the lake at WOT and also used the static method, same result. I'm sure the flywheel is on correctly. I had the same issue on a Johnson 150 previously. I am fairly certain that this shouldn't happen. Is it possible that my timing light is defective?
 

Bosunsmate

Admiral
Joined
Apr 7, 2012
Messages
6,135
Possibly its defective but thats never happened to me.
I suggest you first check that your flywheel is at Odegs when Number 1 piston is at TDC, ive seen slightly off flywheels with broken keys many a time
 

Buddy1263

Recruit
Thread starter
Joined
Jul 2, 2018
Messages
5
I verified that the pointer was at 0 with the piston at TDC before timing it. I will try another timing light. It is the easiest place to start.
 

Buddy1263

Recruit
Thread starter
Joined
Jul 2, 2018
Messages
5
I did it with the spark plugs removed and wires grounded, #1 cylinder with spark plug tester set st 7/16" of an inch, WOT with the timer base against the stop. Then on the lake at WOT. Same result both ways
 

Buddy1263

Recruit
Thread starter
Joined
Jul 2, 2018
Messages
5
Tried another timing light, same result as I expected. Could it be that the Fast Start is not de activating? I could put a longer bolt in to get the additional retard but that doesn't seem like the right solution.
 

Rustywrench

Petty Officer 1st Class
Joined
May 10, 2018
Messages
209
Are you using a timing light with adjustable advance at the light (like automotive)? It has happened to me as I have one like that. OMC had some problem with flywheel hub magnets. Kinda difficult to be sure. Best way is to try another flywheel, but not always easy to get your hands on one? 1991 & later will work.
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
Do you have a manual? I would double check that timing spec around 1980 or so timing was changed to 19 deg
 

Buddy1263

Recruit
Thread starter
Joined
Jul 2, 2018
Messages
5
I was using a inductive Craftsman timing light I got back in the 80's and it doesn't have the advance feature, actually both timing lights were the same model. As for having a manual I don't have one for that particular motor, I was going off the carb cover number for the timing spec. I also found a test method for the Quick Start feature from CDI that I am going to try.
Thanks to all that have contributed with feedback.
 
Top