E25TECIM Help, reconditioning outboard will not idle!!!

thorpe66

Cadet
Thread starter
Joined
Jan 17, 2014
Messages
12
I am reconditioning a 25HP Evinrude, new carb kit, fuel pump and filter checked and cleaned, reed valve checked. The motor will start in neutral, or in F/R and run full to half throttle for as long as I want. When I try to idle the motor it shuts off. have rechecked the carb 4 times. Does anyone have an idea what may be the problem may be?
Appreciate any help! Thanks
 

thorpe66

Cadet
Thread starter
Joined
Jan 17, 2014
Messages
12
The carb was cleaned completely and looks as good as new inside.
Any other thoughts?
 

flyingscott

Fleet Admiral
Joined
Apr 8, 2014
Messages
8,348
What is your compression? Not idling is usually an idle circuit problem or link and syn is not correct.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Helpful to post specifics about carb cleaning and link and sync procedure, also needle adjustment.
 

thorpe66

Cadet
Thread starter
Joined
Jan 17, 2014
Messages
12
The carb was cleaned so well you can eat soup out of it! I found out if your lower plug is fouled but your upper spark plug is clean then you are dealing with a worn lower crank case seal, which in turn will not allow you to run on both cylinders and therefor not idle. I am replacing the lower seal. Thanks for the thoughts, and good boating!
 
Top