dual battery system

reconpi

Recruit
Thread starter
Joined
May 21, 2011
Messages
3
Just bought a pontoon boat that has a dual battery system with a selector switch for battery1, battery 2, all, and off. It has a trickle charger connected as well. when plugging in the trickle charger where should the selector switch be ? when starting the motor where should the selector switch be ? while running the boat where should the selector switch be ? If I disconnect the trickle charger and use a battery charger 10 amp where should it be connected , to which battery same with a "jump start".
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: dual battery system

Think about it. A battery switch is a traffic cop for current flow. If you have it set to BAT 1 that battery and that battery only starts the engine, gets charged from the engine and runs every electrical item on the boat. If you set it to BAT 2 it's the same situation. If you set it to BOTH, both batteries are on-line to start the engine, get charged from the engine and run everything on the boat. Which battery you want to use or protect determines where you set the switch. If BAT 1 is the starting battery, when anchored and running the stereo, fish finder, etc., set the switch to BAT 2. That way you don't run down BAT 1. Underway set the switch to the battery you feel needs charging the most (to BOTH if you wish). Keep in mind how you use the switch depends on how it is wired. If some creative wiring technique was used all of this is out the window.
 
Top