Dry joint Riser on Non- dry joint Manifold?

[Ragazzoni]

This might be close to the solution.. I wonder what makes them say ”must be used with our manifolds” ...
http://www.glmmarine.com/product-manifolds.html

 

[alldodge]

This might be close to the solution.. I wonder what makes them say ”must be used with our manifolds” ...

They are slightly different then Merc because otherwise its patent infringement

 

[Ragazzoni]

They are slightly different then Merc because otherwise its patent infringement

But hopefully same bolt pattern I’ll call them and see if its possible to fit or not... the ”new” mans I got now are china anyway under the merc elbows.

I probably wont buy full kit anyhow so they loose nothing by being honest... (if it dont come out.. ehrmm)

 

[Bondo]

Ayuh,..... Check the gasket surfaces for Flatness,.....

I once found their manifolds to be .020" / .030" low for the exhaust rim, vs: the outer rim on a set of manifolds,....

Decked 'em at my local machine shop, 'n no worries since,....

Used both Merc, 'n aftermarket risers on 'em, always with Merc gaskets though,.....