Dropping RPM's

Gatorsbabe

Cadet
Thread starter
Joined
May 29, 2018
Messages
8
And if you bore one or 2 cylinders, shouldn't all of them be done...it is a 2 stroke.
 

interalian

Commander
Joined
Jul 23, 2009
Messages
2,105
And if you bore one or 2 cylinders, shouldn't all of them be done...it is a 2 stroke.

Not necessarily. If some holes measure OK and clean up with a honing, and the piston is OK (including ring lands not worn), no need to change. If a hole measures out of spec or is scored/pitted, a re-bore for that hole plus a new oversize piston is indicated. 2-smokes aren't that sensitive to bore size if not same in all cylinders from what I've read. That said, I went 30 over on all 4 when I did mine since all the pistons were shot.
 

Gatorsbabe

Cadet
Thread starter
Joined
May 29, 2018
Messages
8
well 2 of the cylinders have large rust & pitting spots in a line around the top of the cylinder....
scoring visible in the other 2. Bad compression in 3 of them. I'd say bore all of them & do oversize pistons & move on.
 
Top