Confused about idle mixture adjustment

racerfern

Cadet
Thread starter
Joined
Jul 31, 2017
Messages
9
I have a 1989 Evinrude 140HP. As far as I can tell it is a Type IV carb and the lower left screw should be a fuel mixture adjustment at idle. The drawing shows a needle valve with spring. However, each of the four carbs has an orifice, not a needle valve. Am I looking in the wrong spot or for the wrong thing?
 

Attachments

  • photo276425.jpg
    photo276425.jpg
    211.7 KB · Views: 0

Joe Reeves

Supreme Mariner
Joined
Feb 24, 2002
Messages
13,262
Those jets in the top inside area of the carburetor throat is a "Idle & Intermediate Air Bleed Jet" that measures air, not fuel.

There are no fuel mixture adjustments on those carburetors..... only brass fixed jets.

I assume that you might have a manual that covers an assortment of engines which can be (and usually is) very confusing. Members on this site will do their bet to keep you straight.
 
Last edited:

racerfern

Cadet
Thread starter
Joined
Jul 31, 2017
Messages
9
Got it, I see now that they are metering jets. #41 (forty one thousandths?) I assume. My idle mixture is excessively rich so I'm thinking a #30 or whatever in that range.

Thoughts?
 

Faztbullet

Supreme Mariner
Joined
Mar 2, 2008
Messages
15,938
The lower jet is the idle and upper is intermediate....bigger is leaner smaller is richer
 

Joe Reeves

Supreme Mariner
Joined
Feb 24, 2002
Messages
13,262
Got it, I see now that they are metering jets. #41 (forty one thousandths?) I assume. My idle mixture is excessively rich so I'm thinking a #30 or whatever in that range. Thoughts?

Are you absolutely sure of the engines year & horsepower? Engine model number?

As "faztbullet" has stated in not so many words...... The air bleed jets measures air, NOT fuel. Going to a smaller ID air jet would increase the fuel flow, making it richer yet.

I should clarify as I modified my original post slightly to eliminate any possible confusion........................

Of the two air bleed jets pictured there..... the "Top" jet is the intermediate air bleed jet...... The "Bottom" jet is the idle air bleed jet.

My 1989 OMC parts manual states that the 1989 "top intermediate" jet is a #54 (.054)...... with the "bottom idle" jet being a #44 (.044).

(Faztbullet... does the above concur with your numbers?)
 

racerfern

Cadet
Thread starter
Joined
Jul 31, 2017
Messages
9
Engine E140TLCEB confirmed on the engine plate. The idle is #41(lower), the upper intermediate is #51, maybe #54. It's back together right now so I will confirm next time I open things up.

My initial thinking was more air would draw more gas but apparently not. A bigger jet just lets more air in, got it. I might switch the idle and intermediate as a test only to see if it leans out a bit at idle. Right now, it's sooo rich that after two hours of running, then docking and shutting off the engine. Immediately pulled out plugs and they were wet with fuel. In fact the outside of all four carbs are usually covered with a gas film. I replaced all the gaskets, floats and properly adjusted the floats.

It's an old tired engine I know, with compression within a couple pounds of 95 across all four. When it sits overnight it floods the next day and that's with the choke system disconnected! BTW, once it starts, it continues to start and run until the next day.
 
Top