coils rubbing against the flywheel

paysho

Cadet
Thread starter
Joined
Aug 14, 2015
Messages
9
Hi,I am new on this forum.I recently have purchase a 1956 3hp evinrude lightwin and I am in the restoration process.
I have installed two new coils (NAPA 18-5181) but they rub against the flywheel.There is not much adjustment on the 3 bolts holding the coils to the plate.
What to do? Can I file them a little bit?
Another question: I also have purchased a carburetor kit for the same engine.The kit have 2 plastic washers,where do they go?Are they for this carburetor?
Thanks
 

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
This has been discussed many times !---There is enuff adjustment on the coils so that they clear.
 
Last edited:

Chinewalker

Fleet Admiral
Joined
Aug 19, 2001
Messages
8,902
Coils MUST be flush with the machined edge of the plate beneath them. There is enough play in the screw holes to allow for this.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
There have been recent reports that the Sierra coils have mis-shapen laminations. If they won't slide back far enough, look for that possibility.
 
Joined
Aug 3, 2010
Messages
60
I checked it with a dial indicator, the crank runs true. The question is, do I try a different brand coil, or try to clearance the flywheel?
gmFeJSb.jpg
 
Top