Cobalt 2005 220 depth finder

[Brahm]

Can someone please tell me how to get the depth finder to work. If anyone has the instructions that would be greatly appreciated

 

[Slip Away]

Re: Cobalt 2005 220 depth finder

I guess you are not alone. Seems like there should be a manual in your packet that came with the boat, but the dozen or
so who posted to this thread below, apparently did not get one either. So I guess send the guy who has the info an e-mail.
If he still is reachable. Otherwise, call your dealer or Cobalt customer service.

http://forums.iboats.com/cobalt-boats/need-help-operation-standard-cobalt-depth-finder-316630.html

 

[Brahm]

Re: Cobalt 2005 220 depth finder

I guess you are not alone. Seems like there should be a manual in your packet that came with the boat, but the dozen or
so who posted to this thread below, apparently did not get one either. So I guess send the guy who has the info an e-mail.
If he still is reachable. Otherwise, call your dealer or Cobalt customer service.

http://forums.iboats.com/cobalt-boats/need-help-operation-standard-cobalt-depth-finder-316630.html

thanks for your reply
I couldnt quite figure out all of your message
Is there in fact someone who has the manual who could copy it for me. I will gladly reimburse that person for time and cost
Just wish i could get the depth finder to work since I ride in low water at times

Thank you

 

[Slip Away]

Re: Cobalt 2005 220 depth finder

You must not have clicked on the thread I linked. Your answer is there. But being an old thread, "Mike 250" may not get your message. You will need to send him a PM. The last time he posted on iBoats was July of 2010. In case it's still unclear, here is the part of the linked thread that has what you are looking for.

My guess is you have the same depth finder I have on my 2005 250. Pushing down on the toggle moves through the menu options. Once you get to the setting you want to change you toggle the switch up to change set-points.

You probably know this much already but as you toggle down through the menu you'll see something like "Un". Once you see this stop and wait a few seconds and it will show the actual depth.

I have the manual at home if you need details. Let me know.

As I also said, you can call customer service at Cobalt, or your dealer, that is what your manual recommends.