Caughing 1986 25 hp Evinrude

stephansloan@msn.com

Recruit
Thread starter
Joined
Jul 19, 2018
Messages
4
I have a 1985 Evinrude 25 that came with a Boston Whaler I purchased. The engine needed work and with searches from this and other pages I have:​
1- cleaned and rebuilt the carburetor​
2- installed a new starter​
3- link and sync​
4- Joe Reeves WOT timing​
The spark appears strong jumping 7/16ths easily and brightly.​
The engine has an occasional miss that occurs at low and high power settings. (Apologies for the camera work)​
Low Speed Miss:​

https://youtu.be/tgJc2TComoY
High Speed Miss:​

https://youtu.be/OMw00Bv2EAg

Where should I look to fix this? ​
Thank you,​
Stephan Sloan ​
 
Last edited:

fireman57

Captain
Joined
Aug 24, 2004
Messages
3,811
When you rebuilt the carbs did you pop the silver welch plugs off and clean the little holes under them?
 

stephansloan@msn.com

Recruit
Thread starter
Joined
Jul 19, 2018
Messages
4
When you rebuilt the carbs did you pop the silver welch plugs off and clean the little holes under them?

Yes- The rebuild kit came with new plugs so all the old ones were knocked out. Each part of the carb was soaked and cleaned in an ultrasonic bath and then blown out with compressed air.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Not exactly low speed. Does it do that at idle, in neutral as well as in gear? Is it shifting into gear smoothly? Is the high speed jet squeaky clean and undamaged?

btw -- didn't see reference to any water pump work. New impeller?
 

stephansloan@msn.com

Recruit
Thread starter
Joined
Jul 19, 2018
Messages
4
Engine starts well and idles well, even smoothly in neutral.
High speed jet is clean (I believe) seat and needle are new from the rebuild kit.
Shifts smoothly without stalling.
I did put in a new water pump as one of the first steps and it pumps well.

I pulled the plugs tonight and they were black and almost wet. Gas tank and line are from West Marine and there is a water separator and filter mounted in the inside of the transom.
 
Last edited:

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
May have a worn clutch dog -- need some more ears (more comments).
 

stephansloan@msn.com

Recruit
Thread starter
Joined
Jul 19, 2018
Messages
4
Hmmmm. Maybe the clutch dog is jumping in and out and that is causing the rough running?
I will try pulling the engine through by hand while in gear to see if I can determine anything other than the drag of the water pump...
Thank you,
Stephan
 
Top