carburetor adjustments

johnHanna64

Recruit
Thread starter
Joined
Sep 4, 2017
Messages
3
1971 Evinrude 60 horsepower Triumph 3 cylinder - adjusted middle carburetor still won't idle at what point do I start adjusting the other two carbs
 

Joe Reeves

Supreme Mariner
Joined
Feb 24, 2002
Messages
13,262
(Carburetor Adjustment - Single S/S Adjustable Needle Valve)
(J. Reeves)

Initial setting is: Slow speed = seat gently, then open 1-1/2 turns.

Start engine and set the rpms to where it just stays running. In segments of 1/8 turns, start to turn the S/S needle valve in. Wait a few seconds for the engine to respond. As you turn the valve in, the rpms will increase. Lower the rpms again to where the engine will just stay running.

Eventually you'll hit the point where the engine wants to die out or it will spit back (sounds like a mild backfire). At that point, back out the valve 1/4 turn. Within that 1/4 turn, you'll find the smoothest slow speed setting.

Note 1: As a final double check setting of the slow speed valve(s), if the engine has more than one carburetor, do not attempt to gradually adjust all of the valves/carburetors at the same time. Do one at a time until you hit the above response (die out or spit back), then go on to the next valve/carburetor. It may be necessary to back out "all" of the slow speed adjustable needle valves 1/8 turn before doing this final adjustment due to the fact that one of the valves might be initially set ever so slightly lean.

Note 2: If the engine should be a three (3) cylinder engine with three (3) carburetors, start the adjustment sequence with the center carburetor.

When you have finished the above adjustment, you will have no reason to move them again unless the carburetor fouls/gums up from sitting, in which case you would be required to remove, clean, and rebuild the carburetor anyway.
 

johnHanna64

Recruit
Thread starter
Joined
Sep 4, 2017
Messages
3
Hi Joe, thanks for answering my post. I saw your same post in another thread few days back and we followed your directions, starting with the center carb. But at this point Im just guessing what is the smoothest slow speed setting, which still doesnt sound smooth. So is this when i move onto the next carb and adjust it in the same way? Or do i need to adjust the other two carbs at all?
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
Each cylinder is fed by its own carb, each has to be adjusted, more than once to get the best idle. However, first you have ensure all 3 carbs are fully closed.
 

johnHanna64

Recruit
Thread starter
Joined
Sep 4, 2017
Messages
3
Then thats what our problem is, we need to close the other two carbs. Headed out to go do that, Ill post the outcome in a few, thanks all.
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
All three throttle shafts (in carbs) fully closed at idle and all start to open at exactly the same time in relation to each other, and exactly the right time in relation to the spark advance. It is futile to try to adjust the mixture if a throttle shaft isn't closed. This is part of what is often referred to as link and sync. Very important if you expect to get a good running motor.
 
Top