Carb Tuning

heyttown

Chief Petty Officer
Thread starter
Joined
Aug 3, 2003
Messages
537
Ok folks 1995 28hp Johnson,(sv type carb) I just rebuilt the carb,reinstalled and it started right up. I took it to the boat ramp and my manual said to run it hard for a couple minutes and pull the plugs and check the color, which I did and they were still very white and dry, So I adjusted my idle mixture needle valve counterclockwise, just like clymer said too and ran it again, this time the plugs came back more a copper/tan color and everything ran decent, I had it adjusted pretty good it wouldnt bog down at any idle speed. The boat sat for a week, took it to the ramp again, started right up, but this time from idle to 1/4 throttle it would bog down and die, anything past 1/4 throttle it ran great.sitting in neutral or idle in gear would be fine, soon as you started the gas till about 1/4 throttle would have problems, I ran it for awile did multiple throttle testing and it ran good,I could go from full throttle to neutral right away, and it did good, before the rebuild I would slowly have to decellerate or it would stall...............Anyways I ran it for awile(almost an hr) and pulled the plugs, the top plug had decent color to it but was very dry, I pulled the bottom plug and it had good color also but was wet. And Ive used almost a full 6gallon tank on the new carb and it seems to be eating the gas, compared to before my rebuild.................. I can tell it could probaby use just a little tweaking as I am very close on the throttle, but maybe just bit a help may get me there faster................if you could point me in the right direction, why is it running better then before the rebuild, but using more gas? any little backyards tips to gettting everything adjusted just right?With the top plug being dry is it running to lean?<br /><br />Sorry this is so long but I wanna try and explain everything as good as possible.
 

jim dozier

Lieutenant Commander
Joined
Jan 8, 2003
Messages
1,970
Re: Carb Tuning

I suspect there are multiple things going on to confuse everybody here. A couple of points. If you run it hard (WOT) and shut it down, the color of the plugs will show you the mixture running off the main jets which are fixed. If you run it at idle or slow speed and shut it down, the color of the plugs will show you the mixture of the idle jets which on many but not all engines are adjustable. Also some idle mixture screws bleed in fuel and some bleed in air so some unscrew to richen and some unscrew to lean, respectively. Check your manual. You may have not set the float adjustment in one or more carbs correctly during the rebuil (you did rebuild the carbs, yes?) and one or more cylinders may be lean or rich or some of both as a result (very confusing in the tune up procedure). Best take off performance is acheived with idle mixture set slightly richer than optimum for idle (say 1/8 to 1/4 turn in the richer direction). Also if your fuel pump has a hole in one of the diaphragms it can make your engine run rich or lean depending on the location of the hole. Also check the fuel lines and connections for air leaks. Last but not least the ignition timing must be synchronized with the carb throttle plates as per your manual. You gotta narrow this down a bit.
 
Top