Carb leaking fuel out front or screen

mksharpe

Cadet
Thread starter
Joined
Sep 6, 2012
Messages
9
1980 Mercury 40 HP. Removed carb, dipped in chemDip. Cleaned with canned air. Reassembled with new gaskets, new float, new seat and needle.

New needle was a tad shorter than old needle so I bent the levels to make them parallel when turning the top upside down. Tested with air and it seemed ok. Then I put it back on the motor and pumped the fuel ball. Gas poured out the front in a steady stream.

Not sure what to try next. Do you think it has something to do with the shorter needle? Guy at parts store assured me it was the correct one. Also, there was no rubber pieces anywhere. Just a metal washer, the seat, and the needle in the bag.

Thanks for any help.
 

oldman570

Lieutenant Commander
Joined
Mar 25, 2011
Messages
1,615
Re: Carb leaking fuel out front or screen

If gas is pouring out of the front of the carb when pumping the primer bulb , then that float , needle and seat are not shuting the fuel flow off as they should. If you still have the old needle and seat, and they are brass and not the rubber tip needle and seat , you can try putting them back in if they look good and reset them and see if that cures the probblem. Ckeck the float to make sure it is good and dose not have fuel in it . If its the old cork style it could be waterloged persay and will not float as it should.JMO
Oldman570
 
Top