carb adjustment packing washer

tomicon

Recruit
Thread starter
Joined
Aug 4, 2016
Messages
2
How do i keep my adjustment needle from backing out when engine is running.
 

hardwater fisherman

Lieutenant Commander
Joined
Mar 19, 2010
Messages
1,725
What motor are you working on? There should be some washers and some packing washers. And the packing nut you tighten. If installed correctly it should not move. My manuals say the packing nut should be tightened until you are able to just turn the needle by hand.
 

hardwater fisherman

Lieutenant Commander
Joined
Mar 19, 2010
Messages
1,725
No Title

That carb appears to have a retainer part number 17 in the diagram. BRP part number 0315232.
 

Attachments

  • photo249757.png
    photo249757.png
    31.2 KB · Views: 1

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Yeah, many motors with needles have a packing nut or "gland nut" that has to be snug to hold the needle setting. I haven't had an issue with those retainers in the '80s motors I have, but suppose they could wear. First step is to make sure the retainer is in place (#17, as hardwater fisherman shows).
 
Last edited:

gm280

Supreme Mariner
Joined
Jun 26, 2011
Messages
14,605
Engines use lots of ways to keep air bleed or fuel bleed needles from moving. Marine engines seem to use packing nuts while yard equipment uses strong springs to hold their settings. So if the packing nut isn't doing the job, maybe buy a carb rebuild kit and install. You also could use some Loc Tite on the threads. JMHO!
 
Top