Brandy new trim sender not working

tpenfield

Moderator
Staff member
Thread starter
Joined
Jul 18, 2011
Messages
19,570
Greetings,

The hits keep on coming as far as boat maintenance this year. I put on brand new trim senders and limit switches on both engines this year.

The starboard engine/outdrive sender works fine. The port side was difficult to get working and adjust. At one point I opened it up to see if there was an obvious defect, but the contacts were fine and the potentiometer section resistance checked out OK. I finally got the thing installed and adjusted. I tested it about a dozen times on dry land and it worked.

The boat went in the water for the season yesterday- and wouldn’t you know it after about 30 minutes the port sender stopped working :( .

So, I’m thinking the wiring connections within the sender might be flaky - or maybe the thing just wasn’t meant to be.

If I have to do an ‘in water repair’ not sure what my options would be.

Any one done a fix ‘on the fly’ of a trim sender? Or any other ideas? Taking the boat out in not a good option ($$$) and my boat hauler guy is pretty booked up for the next month.
 
Top