Boston Whaler Rage engine

lou1945

Recruit
Thread starter
Joined
Jul 10, 2003
Messages
2
I have to replace the block on my 115hp OMC jet drive for this boat. Is there a larger engine that will fit? When I put the new engine in are there any thoughts on how to further protect the engine from sand that stops up the thermostat. I have the optional sand filter on the boat already. Maybe someone has a used 115 engine or block I could get? :confused:
 

clanton

Rear Admiral
Joined
Jul 9, 2001
Messages
4,876
Re: Boston Whaler Rage engine

If the block is not broke, you can sleeve the cylinders. A thru hull water pickup, with different waterpump would solve the sand pickup. What I havent figure out yet is how to drive the pump. Maby a Volvo pump driven from flywheel. My dau has a Four winns with a 115, sorry setup for waterpump. Edited.<br /><br />Bolt belt pulley to flywheel, using the 3 threaded holes, mount Volvo pump to block. You would have to make bracket to mount pump.
 

lou1945

Recruit
Thread starter
Joined
Jul 10, 2003
Messages
2
Re: Boston Whaler Rage engine

Thanks, I like the pump Idea! I may even put in a heat exchanger and two pumps and go with antifreez in the engine. Wouldn't that be great. That way I could mount a real thermostat on the heat exchanger and do away with the crap under the engine. I will have to check but I think I might even be able to use an electric pump for raw water.
 
Top