Boat Gauge Problems - Any help appreciated!

Sapore di Mare

Recruit
Thread starter
Joined
Jul 15, 2011
Messages
3
Hi, I wanted to see if anyone can help me figure out some of the problems I have been having with my boat gauges. I have a 2004 Maxum bowrider (2400 SR).

Last week, my gauges started to act a little funny. The fuel gauge reads below the empty line, and doesnt move. The battery gauge says that the battery is less than 12 V when charging (which isnt true since i checked the battery with a multimeter and it was reading at about 14.5V). The oil pressure was reading at the max when running (i think around 80). The water temp was reading at about 215 (even though I could still keep my hand on the exhaust manifolds for a good 10 seconds without burning them- it use to always run at 175), and the trim gauge was below the scale (it showed the trim moving up and down on the gauge, but it was below the scale on the gauge). The RPMs seemed accurate.

Then three days ago, all the gauges seemed to be working again (on scale), except the fuel which was still completely empty below the line and not moving.

Then the next day, all the problems were back again.

So, I started looking around seeing if the connections were good, etc. I checked the voltage across the gauges, and they all seemed to be reading less than 12V (around 10-11V). I tried tighting some connections, seeing if any wires were split, and now NONE of the gauges are working at all. Perhaps I did something while looking around (or perhaps I shorted something..... im not sure if it is a no no that i tightened all the junction bar screws when the battery was on).

Are there any fuses or circuit breakers that control all of the gauges?

Any ideas on the original problem?

Also, keep in mind that none of the buzzer alarms ever went off at the dash (not sure if they are connected to the gauge directly, or to the sender device directly, etc).

I appreciate any help!
 

kahuna123

Senior Chief Petty Officer
Joined
Jun 2, 2011
Messages
703
Re: Boat Gauge Problems - Any help appreciated!

The 12v feed to the gauges are probably jumped one to the other from the ignition switch. Remove the first feed from the ignition and check the voltage there. Replace if good.Remove the next feed to the second gauge and check there and work your way down. Chances are you have a bad gauge or a bad ground. They are all wired together, if one goes bad it takes them all out.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Boat Gauge Problems - Any help appreciated!

The 12v feed to the gauges are probably jumped one to the other from the ignition switch. Remove the first feed from the ignition and check the voltage there. Replace if good.Remove the next feed to the second gauge and check there and work your way down. Chances are you have a bad gauge or a bad ground. They are all wired together, if one goes bad it takes them all out.

You do not need to disconnect anything to measure voltage. Gauges are daisy chained from one to the next, meaning they are in parallel so losing one does not mean the others will die. The fact that the gauges that are not working are all engine related says the problem is probably with the sending units or their associated wiring. Lastly, if you are measuring only 10-11 volts at the gauges you have a battery charge issue but that will not keep the gauges from working.
 
Top