Boat Electrical Issue

SimpleGreen

Recruit
Thread starter
Joined
Nov 2, 2011
Messages
4
Hello everyone, new to iboats and owning my own boat. Just this past summer I bought a 2001 Bayliner Capri with a 90 HP Mercury 4 stroke Outboard. Worked fine all summer and into the fall (minus the tach bouncing around). I took it out a little over 2 weeks ago and everything was fine, put it on the trailer and parked it. Came back the next morning to take it to get winterized and the battery was dead. Im pretty sure i didnt leave anything on. Charged the battery and hooked it back up and now only the accessories (radio,horn, bilge pump, nav and achor light) all on switches minus the radio work. When I turn the key none of the gauges move, tilt on the throttle and motor dont work, and the motor will not crank. I have no fuses blown that i have found I am at a loss. Any help would be appreciated as I need to get this thing winterized ASAP. Thanks
 

Don S

Honorary Moderator Emeritus
Joined
Aug 31, 2004
Messages
62,321
Re: Boat Electrical Issue

Did you check the fuses on the motor?
 

SimpleGreen

Recruit
Thread starter
Joined
Nov 2, 2011
Messages
4
Re: Boat Electrical Issue

Yup, I have two fuses on the motor both intact. I also checked 4 fuses that are right behind the battery all intact. Those are the only fuses I could locate on the boat. I do have a cercuit breaker on the helm between the gauges and none are popped.
 

mekkamaz

Petty Officer 2nd Class
Joined
Dec 30, 2008
Messages
180
Re: Boat Electrical Issue

Check again your battery terminals for a loose connection or a broke terminal. Also check engine grounding. Looks like you have a no ground.
 

SimpleGreen

Recruit
Thread starter
Joined
Nov 2, 2011
Messages
4
Re: Boat Electrical Issue

How do I check the engine grounding. Sorry, I only have a limited mechanical knowledge.
 

Silvertip

Honorary Supreme Mariner
Joined
Sep 22, 2003
Messages
28,772
Re: Boat Electrical Issue

Grounding isn't "mechanical" it is "electrical". You remove the cables from the battery termiinals. Clean them thorougholy (as in make them shiny bright). Check the terminals on the end of each cable for evidence of corrosion -- such as swelling of the insulation near the terminal. Repair or replace cables if necessary. And remember, each cable has two ends -- one at the battery and the other end at the engine. It does no good to clean one and not the other -- especially if the problem is on the other end. All of the things you say don't work are powered via the engine harness so double check the fuses at the engine.
 

Sea Stomper

Petty Officer 2nd Class
Joined
Nov 9, 2010
Messages
158
Re: Boat Electrical Issue

Get a cheap digital volt meter or test light and teach yourself how to use it. It will help immensely.
 

fucawi

Banned
Joined
May 18, 2011
Messages
1,039
Re: Boat Electrical Issue

Testing earth/ground with a Digital voltmeter.

Turn on whatever works ...put voltmeter between the actual lead of the battery neg terminal and put the other probe on the cable ...push it through the insulaton if neccessary .....if you read a voltage over 0.2v then the earth is bad .. if you read 12v the earth is open circuit
 
Top